HITEC X1 AC Plus: Single Port AC/DC Chargers - Manual (Page 13)

13
The X1 off ers the following lithium charge modes: Charge, Balance Charge,
Fast Charge, Storage and Discharge.
BEFORE SELECTING A CHARGE MODE, IT IS CRITICAL THAT YOU
SELECT THE CORRECT TYPE OF LITHIUM BATTERY TO BE CHARGED.
FAILURE TO DO SO CAN RESULT IN DAMAGE TO THE BATTERY AND
POSSIBLE EXPLOSION.
Selecting a Lithium Battery Type
From the “
USER SET PROGRAM->
” screen, press the ►
button once to advance to the “
V.Type
“ screen. The
default setting is “
LiPo 3.7V
“.
Press the ► button once and the voltage value will
begin fl ashing. Use the ✚ or ▬ buttons to choose from the following options:
“
LiPo 3.7V
“, “
LiIo 3.6V
“ or “
LiFe 3.3V
“. Once you have selected the correct
battery type, press the ► button to save your settings.
This program is only suitable for charging/discharging Lithium (LiPo/LiIon/LiFe)
batteries.
BEFORE YOU BEGIN CHARGING YOUR BATTERY, MAKE SURE YOU
HAVE READ AND UNDERSTAND ALL OF THE WARNINGS AND SEFETY
INFORMATION CONTAINED ON PAGES 4-7.
IN THE CHARGE MODE, LITHIUM BATTERIES CAN BE CHARGED WITH-
OUT THE USE OF A BALANCE ADAPTOR. A BALANCE ADAPTER CAN BE
USED, BUT IT IS NOT REQUIRED. BALANCE CHARGE MODE IS RECOM-
MENDED FOR ANY BATTERY WITH A BALANCE LEAD.
See page 12 for the appropriate charging connections setup for this operation.
First, select the correct battery type by following the instructions above. Once
you have set the correct battery type, press the ■ button once to return to the
“
USER SET PROGRAM->
“ screen. Press the ■ button to enter the “
PROGRAM SE-
LECT
“ screen. On this screen you should see the type
of battery you have selected.
Charge Modes
Lithium Charge Mode
PROGRAM SELECT
LiPo BATT
USER SET
PROGRAM->
LiPo
V.Type
3.7V
Lithium
Warning
Warning
Note