HITEC X1 AC Plus: Single Port AC/DC Chargers - Manual (Page 18)

18
First, select the correct battery type by following the instructions on page 13.
Once you have set the correct battery type, press the ■ button once to return
to the “
USER SET PROGRAM->
“ screen. Press the ■ button again to enter the
“
PROGRAM SELECT
“ screen. On this screen you should
see the type of battery you have selected.
Press the
► button once to enter the “
CHARGE
“ screen.
Now use the ✚ or ▬ buttons to change from “
CHARGE
“
mode to “
STORAGE
“. Press the ► button again and the amp rate value will
begin fl ashing. Use the ✚ or ▬ buttons to adjust the value to the desired rate.
Follow the instructions provided with your battery when setting the amp rate.
Press the
► button again and the voltage value will begin fl ashing. Use the ✚
or ▬ buttons to adjust the value to the desired rate. The voltage and cell count
should match the values listed on the battery label.
Press and hold the
► button and charging will begin.
Once charging has commenced, the charger will
display the following real-time information: Battery
type/cell count, charging current, battery voltage, charging time and charged
capactiy.
This function is for charging/discharging batteries that will not be used im-
mediately. The program is designed for charging/discharging batteries up-to or
down-to safe storage levels. The program will automatically begin to discharge
if the current state of the battery exceeds the voltage level for storage.
BEFORE YOU BEGIN CHARGING/DISCHARGING YOUR BATTERY, MAKE
SURE YOU HAVE READ AND UNDERSTAND ALL OF THE WARNINGS AND
SEFETY INFORMATION CONTAINED ON PAGES XX-XX.
IN STORAGE MODE, LITHIUM BATTERIES CAN BE CHARGED WITH OR
WITHOUT THE USE OF A BALANCE ADAPTOR. USE OF A BALANCE
ADAPTOR IS RECOMMENCED WHENEVER POSSIBLE.
See page 12 for the appropriate charging connections setup for this operation.
Lithium Storage Mode
Lithium
Li3s 1.2A 12.69V
STO 022:43 00682
Note
Warning
LiPo STORAGE
0.1A 3.7V(1S)
PROGRAM SELECT
LiPo BATT