HITEC X1 AC Plus: Single Port AC/DC Chargers User Manual
Page 3
3
Introduction
Congratulations on your choice of the Hitec X1 charger from Hitec RCD USA.
The Hitec X1 is a high-performance, microprocessor controlled charger/dis-
charger with battery management capabilities that are suitable for use with
most popular battery types. The X1 also features integrated balancing for
six-cell, Lithium-Polymer (LiPo), Lithium-Ferrite (LiFe) and Lithium-Ion (Li-Ion)
batteries.
Please read this entire operating manual before using the X1 Charger. If you
are unsure of its proper operation after reading the manual, please seek advice
from an experienced hobbyist or someone familiar with proper battery charg-
ing procedures.
THE CHARGING AND DISCHARGING OF RC HOBBY BATTERIES CAN BE
DANGEROUS. FAILURE TO FOLLOW THESE EXPLICIT WARNINGS CAN
RESULT IN PROPERTY DAMAGE AND/OR LOSS OF LIFE.
A
NEVER LEAVE YOUR CHARGER UNATTENDED WHILE IN OPERATION.
A
NEVER CHARGE ON OR AROUND COMBUSTIBLE MATERIALS.
A
NEVER CHARGE A DAMAGED BATTERY PACK.
A
LOW COST, NO-NAME BATTERY PACKS POSE THE MOST DANGER. WE REC-
OMMEND YOU ONLY USE BATTERY PACKS THAT ARE SOLD AND WARRAN-
TIED BY A REPUTABLE COMPANY.
A
IT IS HIGHLY RECOMMENDED THAT YOU UTILIZE A SAFETY DEVICE SUCH
AS A STEEL CASE OR LIPO SACK™ WHILE CHARGING LITHIUM CHEMISTRY
BATTERIES.
A
IT IS HIGHLY RECOMMENDED THAT YOU KEEP AN OPERABLE “CLASS A” FIRE
EXTINGUISHER IN THE CHARGING AREA.
FAILURE TO FOLLOW THESE WARNINGS CAN BE CONSIDERED NEGLI-
GENCE BY THE OPERATOR AND MAY NEGATE ANY CLAIMS FOR DAM-
AGES INCURRED.
Hitec RCD USA will not be held responsible for any damages or injuries that
may occur by persons who fail to follow these warnings or who fail to properly
follow the instructions in this manual.
Warning