HITEC X1 AC Plus: Single Port AC/DC Chargers - Manual (Page 26)

26
Lithium Save/Load Data
The Save Data and Load Data programs make it easy to store and load charge
and discharge profi les for up to 5 batteries. Data can be saved for each battery
type and each charge mode available with the X1. This allows you to call back
data for each battery when charging or discharging without having to set up
the program over again. You can also edit settings for each saved battery.
Press the ■ button repeatedly until you reach the “
SAVE
DATA
“ program. Press the ► button to enter the pro-
gram. When you enter the program, the profi le number will be fl ashing. Use the
✚
or ▬ buttons to choose which profi le (1-5) you wish to edit.
Press the ► button again and the battery type will
begin fl ashing. Use the ✚ or ▬ buttons to choose a
battery type.
Press the
► button again and the voltage rate value
will begin fl ashing. Use the ✚ or ▬ buttons to set the
voltage rate. This should match the voltage listed on the battery label.
Press the ► button again and the battery capacity will
begin fl ashing. Use the ✚ or ▬ buttons to set the bat-
tery capacity. This should match the battery capacity listed on the battery label.
Press and hold the ► button and you will be taken to
the “
CHARG
“
E
screen. Use the ✚ or ▬ buttons to choose
from the available charge modes.
Press and hold the
► button and the amp rate value
will begin fl ashing. Use the ✚ or ▬ buttons to set the
amp rate.
* If this profi le is for a NiMH/NiCD battery, simply press and hold the ► button
and the profi le will be saved. If this profi le is for a LiPo battery continue to the
next step. See the end of this section for instructions regarding the Manual and
Automatic Modes available with charging NiMH/NiCD batteries.
Save/Load Data Programs
Save Data Program
SAVE [01] NiMH
3.7V 5000mAH
SAVE [01] LiPo
3.7V 5000mAH
SAVE [01] LiPo
7.4V 5000mAH
SAVE [01] LiPo
7.4V 5400mAH
LiPo CHARGE *
0.8A 11.1V(3S)
LiPo CHARGE *
5.4A 11.1V(3S)