Trace odor carbon filter installation – Labconco XPert Filtered Balance Stations 3962622 User Manual
Page 57
Advertising
Chapter 6: Maintaining Your Filtered Enclosure
Product Service 1-800-522-7658
53
Trace Odor Carbon Filter Installation
In the event that low volumes of solvents are required, a Trace Odor Carbon Filter
can be installed.
1. Remove the screws (2) located on each side of the upper diffuser.
2. Lift and remove the upper diffuser.
3. Place the Trace Odor Carbon Filter on top of the HEPA filter with the gasket-
side DOWN. Use care when maneuvering past the airflow sensor. Be careful
not to harm the HEPA filter media that is exposed.
4. Replace the upper diffuser
5. Replace all screws.
Upper Diffuser
Trace Odor
Carbon Filter
Airflow Sensor
Advertising
This manual is related to the following products: