Labconco Fume Adsorbers 3955422 - Manual (Page 10)

Chapter 2: Prerequisites
Product Service 1-800-522-7658 6
Location and Air Current Requirements
The Fume Adsorbers have been designed to contain hazardous fumes by negating
typical cross drafts and turbulence within the opening. As precautionary safety
measure and a higher level of quality management, it is recommended that the
Fume Adsorber be placed in an area to avoid:

High traffic areas where walking might cause an air disturbance or be a
nuisance.

Overhead or wall HVAC diffusers, fans, radiators or other lab equipment
producing air currents.

Next to doorways or windows that may be opened.
Do not position the unit so that it is difficult to operate the main
disconnect device.
Ne placez pas l'appareil de sorte qu'il est difficile de faire
fonctionner le dispositif principal de déconnexion.
Electrical Requirements
Standard duplex electrical receptacles should be nearby for connecting the Fume
Adsorber. See the nameplate on the rear of the enclosure for rated electrical
service.
Space Requirements
The dimensions for the different Fume Adsorber models are shown in Appendix B:
Dimensions.
!