Labconco Protecto Series Evidence Drying Cabinets 3400004 - Manual (Page 10)

Chapter 3: Getting Started
Product Service 1-800-522-7658 6
If the cabinet was damaged in transit, you must file a claim directly with the
freight carrier. Labconco Corporation and its dealers are not responsible for
shipping damages.
Do not discard the carton or packing material for the cabinet until all of the
components have been checked, installed and tested.
3’ Cabinet Sizes
The 3’ Cabinet is secured to the pallet using four transport brackets, two on
each side. To remove the brackets, do the following:
1. Using the ½-inch wrenches, loosen and remove the bolts and locknuts
that secure the brackets to the pallet.
2. Using a ½-inch wrench, loosen and remove the nuts and bolts
securing the transport brackets to the bottom of the cabinet.
3. Discard the brackets, shipping nuts and bolts.
The cabinet is now ready to be removed from the pallet.
NOTE: A ramp has been provided attached to the wood pallet. Follow
the instructions on the face of the cabinet for safe removal.
After removing the cabinet from the pallet, carefully remove plastic wrapping
around the cabinet, and open the cabinet door. Locate the two transport
brackets attached to the face of the cabinet liner. Using a #2 Phillips
screwdriver, remove the screws securing the brackets, discard the brackets,
and reinstall the screws.
4’ & 5’ Cabinet Sizes
The 4’ & 5’ Cabinets are secured to the pallet using four transport bolts
securing the cabinet to the pallet. To remove the bolts, do the following:
1. Using the ½-inch wrench, loosen and remove the bolts that secure the
cabinet to the pallet.
2. Discard the bolts and washers.
The cabinet is now ready to be removed from the pallet.
After removing the cabinet from the pallet, install the four Leveling Legs into
the bottom of the cabinet. Leveling Legs are located in the lower cabinet
compartment. Then, carefully remove the plastic wrapping around the
cabinet, and open the cabinet doors. Locate the two transport brackets
attached to the face of the cabinet liner. Using a #2 Phillips screwdriver,
remove the screws securing the brackets, discard the brackets, and reinstall
the screws.