Labconco Protecto Series Evidence Drying Cabinets 3400004 - Manual (Page 13)

Chapter 3: Getting Started
Product Service 1-800-522-7658 9
Drain Options - UV Lamp Models
(Model # 34000-00
thru -04, 34040-00 thru -04 & 34050-00 thru -04 only)
NOTE: These models can either drain to a bucket, already located in the
lower storage area, or the bucket can be removed, and an optional Drain
Kit (#3928200) can be installed. The optional drain kit allows the cabinet
to drain to a nearby floor drain.
On units equipped with the drain bucket:
NOTE: The drain bucket had a working capacity of approximately
1.5 gallons. Periodically monitor the liquid level in the bucket during
decontamination or washdown operations.
1. Access the bucket by opening the bottom storage area door on the
front of the cabinet.
2. Before using, ensure the bucket is in its correct position under the
drain.
To install the Drain Kit (#3928200):
NOTE: The drain line should be routed to a floor drain with an air
gap only. NEVER directly connect the drain line to a sewer or drain
system, or use a stand pipe, to prevent backflow into the cabinet.
1. Remove the bucket from the lower storage area and save for possible
reuse.
2. Connect the drain hose assembly to the tail pipe of the drain (on the
bottom of the drain assembly). Push the drain assembly up onto the
stand pipe until it is fully seated.
3. Hand-tighten the compression ring of the drain assembly to the tail
pipe until it is secure.
4. Route the drain hose through the appropriate hole in the bottom rear
panel of the cabinet.
5. Route the drain hose to the floor drain and secure the end of the hose
to prevent it from moving.
6. Pour water into the cabinet drain, and inspect the entire drain system
for leaks. Tighten any leaking fittings.