Wash down models, Fan/drain pump switch, Filter system light – Labconco Protecto Series Evidence Drying Cabinets 3400004 User Manual
Page 27
Chapter 5: Using the Cabinet
Product Service 1-800-522-7658
23
Wash Down Models
(Model # 34000-10 thru -14,
34040-10 thru -14 & 34050-10 thru -14)
Fan/Drain Pump Switch
The cabinet Fan/Drain Pump switch is located on the upper front of the
cabinet, as shown in Figure 5-1a. Turning the switch to the “Fan” position
starts the blower, drawing air into through the cabinet. Turning the switch to
the “Drain Pump” position starts the drain pump.
Do not operate the pump dry for more than 5 minutes.
Filter System Light
The Filter System Light will illuminate if the differential pressure across the
filters becomes excessive. If lit, first inspect or replace the two prefilters. If lit
with clean prefilters, replace the HEPA filter.
NOTE: If the Filter System Light illuminates during use, finish the drying of
the evidence in the cabinet, and then correct the problem before using the
cabinet again.
Figure 5-1a