Labconco Protecto Series Evidence Drying Cabinets 3400004 - Manual (Page 14)

Chapter 3: Getting Started
Product Service 1-800-522-7658 10
Drain Options - Wash Down Models
(Model # 34000-
10 thru -14, 34040-10 thru -14 & 34050-10 thru -14 only)
NOTE: This model is designed to have its drain hose routed to a nearby
floor drain.
To install the drain hose assembly:
NOTE: The drain line should be routed to a floor drain with an air
gap only. NEVER directly connect the drain line to a sewer or drain
system, or use a stand pipe, to prevent backflow into the cabinet.
1. Remove the packing materials securing the hose to the back of the
cabinet.
2. Route the drain hose to the floor drain and secure the end of the hose
to prevent it from moving.
Water Supply Connection - Wash Down Models
(Model # 34000-10 thru -14, 34040-10 thru -14 & 34050-10 thru -
14 only)
NOTE: This model has a cabinet water shut off valve located behind the
lower front door. The valve should be in the “off” position whenever the
unit is not being washed down.
1. Connect the water supply hose (the stainless steel braided hose) to a
domestic water line, equipped with a shut off valve, and ending in a
3/4–inch male garden hose connector.
2. Ensure the water supply valve is in the “off” position.
3. Slowly open the water line shut off valve.
4. Check the cabinet’s water supply hose for leaks.
5. Slowly open the cabinet shut off valve, and check again for leaks.
6. Set the spray gun nozzle to “shower” and slowly pull the trigger.
7. When water flows steadily from the gun, the cabinet shut off valve
can then be turned to the “off” position.