Labconco Protecto Series Evidence Drying Cabinets 3400004 User Manual
Page 15
Chapter 3: Getting Started
Product Service 1-800-522-7658
11
Preparing the Evidence Drying Cabinet for
Operation
After the evidence drying cabinet has been removed from its pallet and
positioned in its final location, you must:
1. Remove the tie and/or tape securing the door, the lower storage area
door, and the filters on top of the unit.
2. Ensure that the transport brackets have been removed from the front
of the cabinet liner.
Note: The following are located in a box in the lower storage space:
• User’s Manual
• Power Cord
• Product Registration Card
• UV Security Lock Key(s) (model #s 34000-00 thru -04,
34040-00 thru -04 & 34050-00 thru -04 only)
• Drain Strainer Cup & Grid
• Rubber Drain Stopper
If you did not receive one or more of the components listed for the
cabinet, or if any of the components are damaged, contact Labconco
Corporation immediately for further instructions.
3. Using a step ladder, remove the tape and/or packaging material
around the top of the unit.
4. Plug the power cord into the back of the cabinet, and then into an
appropriate outlet. Install the Key into the UV Security lock on the
upper panel on those models equipped with a UV light.