Rocktron HUSH Ultra - Manual (Page 19)

19
The parameters provided in this function affect ALL presets (i.e. the settings stored for these parameters
are the same for all presets).
The PARAMETER SELECT knob will allow you to access these Global parameters:
GLOBAL Function
The HUSH OFFSET parameter allows you to globally (all presets) adjust the HUSH ® Ex-
pander Threshold. This means that if this parameter is altered from 0(dB) to +3(dB), the
Expander Threshold will be 3dB higher for all presets. This feature can be useful when
switching from a quiet guitar with passive electronics to a noisy guitar with active elec-
tronics, as the active guitar would require a higher Threshold level in all presets.
MIDI RECEIVE CHANNEL - 1.. 16 OMI The default setting is OMNI
The PROGRAM CHANGES function allows you to globally turn ON/OFF the HUSH Ul-
tra to accept Program Changes from other devices. The default setting is ON.
The PRESET MAP function allows you to globally turn ON/OFF the PRESET MAPPING
function. The preset mapping allows the HUSH Ultra to receive a Program Change from
a MIDI Controller for one preset, but to actually recall a different preset. See PRESET
MAPPING section later in this manual for more detailed information on PRESET MAP-
PING.
The CHNLINK “ON/OFF” determines whether the CHNLINK Function is active
or “ON” or not active or “OFF”
CONTINUOUS CONTROLLER NUMBER
EXPANDER THRESHOLD 1 parameter determines the level at which downward
expansion begins. For example, if the EXP THRESHOLD was set at -20(dB) and
the input signal dropped below -20(dB), downward expansion would begin.
GATE THRESHOLD 1 control is used to determine the level at which the gate will
begin to operate. As the input signal drops below this level, the gate will activate
and downward expansion will begin.
EXPANDER THRESHOLD 2 parameter determines the level at which downward
expansion begins. For example, if the EXP THRESHOLD2 was set at -20(dB) and
the input signal dropped below -20(dB), downward expansion would begin. Note
that this is only used with the MIDI MCC Link is active.
GATE THRESHOLD 2 control is used to determine the level at which the gate will
begin to operate. As the input signal drops below this level, the gate will activate
and downward expansion will begin. Note that this is only used with the MIDI
MCC Link is active
EXPANDER THRESHOLD 3 parameter determines the level at which downward
expansion begins. For example, if the EXP THRESHOLD3 was set at -20(dB) and
the input signal dropped below -20(dB), downward expansion would begin. Note
that this is only used with the MIDI MCC Link is active.
HUSH OFFSET
MIDI RX
PROGRAM CHANGES
PRESET MAP
CHNLINK
CC_NUM
EXP THRESH1
GATE THRESH1
EXP THRESH2
GATE THRESH2
EXP THRESH3