Rocktron HUSH Ultra - Manual (Page 7)

7
CH. A (MONO) IN jacks
This XLR and ¼" mono jack provide inputs to the left channel of the HUSH Ultra. Use either the XLR
jack or the ¼" jack when connecting, but not both together. When using only one input use the "CH. A
(MONO) XLR or ¼" jack".
CH. B IN jacks
This XLR and ¼" mono jack provide inputs to the right channel of the HUSH Ultra. Use either the XLR
jack or the ¼" jack when connecting, but not both together.
CH. A jacks
This XLR and ¼" mono jack provide the output from the "CH. A (MONO)" channel of the HUSH Ultra.
CH. B jacks
This XLR and ¼" mono jack provide the output from the "CH. B" channel of the HUSH Ultra.
Note: When "CH. A" is used as a single signal source, the signal will be present in both the "CH.
A" and "CH. B" outputs.
PHANTOM POWER jack
This 2.5mm pin jack accepts power from the 9VAC adapter supplied with a Rocktron foot controller (sold
seperately). See section called "PHANTOM POWER" for more information.
MIDI IN jack
Use this jack to plug in your MIDI controller. This jack is a 7 Pin MIDI Jack, however a standard 5 Pin
MIDI Cable can be used. If plugging into a Rocktron MIDI controller such as the All Access,
MIDI Mate or MIDI Xchange, we recommend using the Rocktron RMM900 7-Pin MIDI Cable
(sold separately). Pins 6 and 7 supply phantom power to the Rocktron MIDI controller when
using the RMM900.
MIDI THRU/OUT jack
Use this jack to plug into the first MIDI controllable device in your signal chain.
POWER jack
Plug the included 9VAC adapter into this jack to provide power to the unit. Please follow all
precautions as outlined in this manual and the manuals of the products that are being plugged
into the HUSH Ultra. Failure to follow these precautions may void the warranty.
3. HUSH ULTRA Rear Panel
1
2
3
4
5
6
7
8