Rocktron HUSH Ultra - Manual (Page 21)

21
MIDI CTRLINK:
For most users using individual presets will cover your needs however there are some power users
that may desire to consider the following.
If you have a 4 channel amplifier that you can use 4 controllers to change channels you can program
1preset using the MCC LINK.
CTRLINK OFF ; Determines whether function is active
CC_NUM_A OFF ..120 ;Assigns controller number
This correlates to recall HUSH_ THRSH_A and HUSH_ GATE_A when determined that the control-
ler assigned matches and that a value greater than 63 has been detected as the channel select value.
This will function with latching and momentary switching.
DEFAULT MCC
CC_NUM_A will map to HUSH_ THRSH_A and HUSH_ GATE_A parameters. 85
CC_NUM_B will map to HUSH_ THRSH_B and HUSH_ GATE_B parameters. 86
CC_NUM_C will map to HUSH_ THRSH_C and HUSH_ GATE_C parameters. 87
CC_NUM_D will map to HUSH_ THRSH_D and HUSH_ GATE_D parameters. 88
TBYPASS MCC controller to be used for TRUE BYPASS 89
Note: It is recommended that PROGRAM CHANGES in the GLOBAL FUNCTION is set to off
when using the MCC LINK mode. MCC LINK is programmable per preset if a combination of pro-
gram changes and the MCC LINK is desired. When the CTRLINK is on and you are out of the EDIT
MODE and you have sent any of the mapped controllers to the Hush Ultra the Hush Threshold and
Gate Threshold controls will automatically map to the appropriate selection HUSH_ THRSH_A , B,
C or D. Example: A Midi controller sends MCC 87 with a value of 127 when you adjust the Hush
Threshold you will see HUSH_ THRSH_C on the display. Thus the HUSH ULTRA knows that set C
is currently being used.