Vortech 2009-2010 5.7L Hemi Cars (Charger, Challenger, 300C) User Manual
Page 15
P/N: 4CL020-015 v1.0, 12/02/2014
©2014 Vortech Engineering, Inc
All Rights Reserved, Intl. Copr. Secured
1
A. Disconnect negative cable at the battery.
B. Remove the plastic engine covers and set
aside.
C. Remove the valve cover breather hose from the
factory air inlet duct. Remove the air filter and all
ducting upstream of the throttle body.
D. Unplug the IAT (Inlet Air Temperature) sensor
connector and remove it from the air filter hous-
ing. Set it aside for later use.
E. Remove the accessory drive belt.
F. Unplug the fan electrical connector, then remove
fan shroud hardware. Pull up and remove the
electric radiator fan assembly from the vehicle
(cooling system may need to be drained and
upper radiator hose removed).
G.
2009-2010 Challenger A/T Only: Using an ap-
propriate power steering pulley removal tool,
remove the power steering pump pulley from
the pump.
H.
2009-2010 Challenger A/T Only: Install the sup-
plied power steering pulley hub onto the power
steering pump so that it is flush with the end of
the shaft. (See Fig. 1-a)
1.
PREPARATION AND REMOVAL
Fig. 1-a (A/T Only)