Vortech 2009-2010 5.7L Hemi Cars (Charger, Challenger, 300C) - Manual (Page 35)

P/N: 4CL020-015 v1.0, 12/02/2014
©2014 Vortech Engineering, Inc
All Rights Reserved, Intl. Copr. Secured
21
IMPORTANT! To ensure trouble-free programming of your vehicle's computer:
• Make sure the vehicle's battery is sufficiently charged.
• Turn off all accessories and close doors to prevent unnecessary drain on the battery.
• Do not attempt to program your vehicle while a battery charger is connected.
• Improper battery voltage will result in failure of the programming process.
• Do not disconnect the cable or turn off the ignition during programming.
12. REFLASH COMPUTER
A. Reconnect the battery.
B. Locate the vehicles OBD2 connector located
below the dash on the driver’s side of the
vehicle.
C. Attach the OBD2 connector from the Flash
tool that is provided in the kit to the vehicle’s
OBD2 port. Make sure this connector is seat-
ed all the way in the vehicle’s OBD2 port. You
do not want this connector coming out during
programming or damage may occur to the
vehicle’s ECM.
D. The Reflash tool should power up and display
three parameters. (See Fig. 13-b)
1. Tune Vehicle
2. Scan Tool
3. Settings
E. Select “Tune Vehicle” by pressing the icon.
F. Read the disclaimer entirely, then select
agree and press ENTER.
G. At this point follow the instructions on the
screen displayed on the reflash tool. If you
have any questions, either refer to the manu-
al that is provided with the reflash tool or con-
tact our service department for further assis-
tance.
H. Turn the ignition on (do not start the vehicle).
Set the parking brake and press the ENTER
button to continue.
I. SELECT TUNE will be displayed at the top of
the screen. Select the appropriate tune for
your vehicle. You will have a choice of two to
choose from:
1. Vortech (used for installing kit)
2. Original Backup
J. Continue to follow the screen and when fin-
ished, unplug the reflash tool from the vehi-
cle’s OBD2 port.
NOTE: Do not disturb the cable, or turn
the ignition off during this time.
If the programming is disrupted,
the computer will not start or
run your vehicle!
Fig. 13-a (inTune Programmer)
FLASH TOOL
OBD2 CABLE
Fig. 13-b (inTune Touchscreen Display)