Vortech 2009-2010 5.7L Hemi Cars (Charger, Challenger, 300C) User Manual
Page 32
P/N: 4CL020-015 v1.0, 12/02/2014
©2014 Vortech Engineering, Inc.
All Rights Reserved, Intl. Copr. Secured
18
TO FUEL PUMP
TO WIRING HARNESS
Fig. 11-d
J. Locate the factory fuel pump wires under the rear
seat driver’s side. Remove the tape from the wires.
Separate the blue with orange or blue with red
depending on model year (See Fig. 11-d).
K. Cut the blue with red/orange trace wire leaving
approximately 4”out of the fuel pump. Attach the
12ga. orange wire provided in your kit to the 12ga.
orange wire from the FPB. Attach the other end to
the fuel pump. This wire will power the fuel pump.
(Refer to wiring diagram Fig. 11-h)
L. Attach the 14ga. red wire provided in your kit to
the 14ga red wire from the FPB. Attach the other
end to the blue with red/orange trace wire into the
OEM wire harness. (Refer to wiring diagram Fig.
11-h)
NOTE:
Crimp on connectors are provided
but it is recommended that all of the
wire connections be soldered and
insulated.
11. FUEL PUMP VOLTAGE BOOSTER INSTALLATION con’t
NOTE:
Refer to the fuel pump wiring dia-
gram that is provided for further ex-
planation if needed (Fig. 11-h).