Vortech 2009-2010 5.7L Hemi Cars (Charger, Challenger, 300C) User Manual
Page 25
P/N: 4CL020-015 v1.0, 12/02/2014
©2014 Vortech Engineering, Inc
All Rights Reserved, Intl. Copr. Secured
11
8.
CHARGE AIR COOLER/DISCHARGE ASSEMBLY INSTALLATION
A. Remove the screws securing the coil pack that’s
3rd from the front of the vehicle on the driver side.
Install the supplied discharge tube support bracket
on top of the coil pack, securing it to the engine
using the factory coil pack screws (See Fig. 8-a).
On the passenger side, repeat the same step but
use the 1st coil pack, closest to the front of the
vehicle.
B. Remove the upper alternator bolt & discard. It
will not be reused. Install the supplied bolt into
the upper alternator mount. Be sure to use the
provided washers.
C. Once the supplied bolt is in place, slide on the
supplied .155” spacer & thread on provided nut &
washer by hand. Do not tighten all the way. (See
Fig. 8-b)
D. Using a 15mm socket, remove the screw to the left
of the throttle body, directly above the thermostat
housing. Set screwaside as it will be reused.
E. Locate supplied charge air cooler support. Notice
the bottom of the charge air cooler support is slot-
ted (See Fig. 8-c). Slide the slotted section of the
charge air cooler support in between the .155”
spacer & washer closest to the nut previously
installed on the upper alternator mount. Once the
slotted section of the charge air cooler support is in
place, locate the 15mm screw previously removed
& install through the upper tab of the charge air
cooler support, threading the screw back into its
original location. (See Fig. 8-d)
F. Tighten 15mm screw & upper alternator mount
hardware. Place the charge air cooler on top of
the charge air cooler support.
Fig. 8-a
Fig. 8-b
Fig. 8-c
Fig. 8-d
.155” Spacer
Discharge Tube
Support Bracket