Vortech 2009-2010 5.7L Hemi Cars (Charger, Challenger, 300C) User Manual
Page 19
P/N: 4CL020-015 v1.0, 12/02/2014
©2014 Vortech Engineering, Inc
All Rights Reserved, Intl. Copr. Secured
5
A. Remove the three bolts securing the power steer-
ing pump to the head.
2009-2010 5.7L engines
with M/T require removal of the inlet fitting for
the power steering pump to be replaced with the
supplied fitting. Set aside the hose as it will be
used in a later step. Refer to Fig. 5-b, 5-c & 5-d
for final installation reference
B. Loosely attach the steel bracket to the back of
the primary mounting plate.
C. Attach the supercharger mounting plate to the
primary mounting plate using the supplied M8
x90mm bolts and spacers.
D. Without installing hardware, sandwich the
power steering pump between the steel
plate and the supercharger mounting plate.
At this point, tighten the two bolts attaching the
steel bracket to the primary mounting plate.
(Loosely installed in Steb B.)
5.
SUPERCHARGER MOUNTING PLATE INSTALLATION
Fig. 5-a
NOTE:
This is difficult to accomplish with the
power steering lines connected. It may be
easier to completely remove the power
steering pump from the vehicle and install
onto the mounting bracket assembly out
of the vehicle.
SUPERCHARGER
MTG PLATE
PRIMARY MTG
PLATE
STEEL
BRACKET
Fig. 5-b (2009-2010 5.7L Challenger M6)
NOTE:
2009-2010 5.7L Challenger M6 Only:
continue with steps E, F, G. All other sys-
tems reattach the power steering lines now
and skip to Section 6.
Fig. 5-c (2009-2010 5.7L Challenger M6)
Fig. 5-d (2009-2010 5.7L Challenger M6)