Vortech 2013 Scion FR-S and Subaru BRZ - Manual (Page 14)

P/N: 4TF020-010 v2.1, 05/14/2013
©2013 Vortech Engineering, Inc
All Rights Reserved, Intl. Copr. Secured
7
S. In the ProECU software menu bar (at the top of the window):
Select ‘Tools’, then > ‘Detect Vehicle’. A new window will appear
with ‘Program Engine ECU’ highlighted. Select [OK].
T. Select [Program ECU] in the following window. It will take a few
minutes for this process to complete. After programming the
ECU, follow the on-screen instructions to cycle the ignition ON,
OFF etc. It is important that this is done in sequence with the
appropriate time delays as directed.
U. The message ‘Programming Sequence completed’ should appear.
Select [Ok]. The re-flash step is now complete.
NOTE:
It is possible that you will come across an ECU version that
EcuTek has not seen. It will not be possible for you to program
this ECU until EcuTek has been supplied with certain information
about the specific ECU. The ‘Dump Details for EcuTek’ button
saves certain information from this ECU. The information is stored
in a file that will be saved into the ‘C:\EcuTek\RomDumps’ folder.
The name of the file will be displayed as it is saved.
This information should be sent to EcuTek using the Website
Form, together with a clear photograph of the ECU label and
details of the type of car (please include Model Year and Manual
or Auto gearbox) from which the ECU originates. EcuTek will then
supply an updated version of ProECU that will be capable of
programming the ECU. You will then need to send the new file
received from EcuTek over to Vortech with your Dongle ID and
License Key to have the revised calibration completed.
Please note that it is not something that can be done while-you-
wait. Turnaround time is likely to be 3 to 7 days for support of a
new ECU. It is therefore important for the tuner to check that the
ECU version is supported well before the car is scheduled to be
reprogrammed – this will avoid a panic situation for all parties
involved.
Please note that it is not possible to open ROM Dumps in ProECU
until the file has been emailed to EcuTek.