Vortech 2013 Scion FR-S and Subaru BRZ - Manual (Page 40)

P/N: 4TF020-010 v2.1, 05/14/2013
©2013 Vortech Engineering, Inc
All Rights Reserved, Intl. Copr. Secured
33
Fig. 7G
G. Install the supplied 3” dia. x 1.75” sleeve and #48
clamps onto the throttle body. Locate the supplied
discharge tube 'D'. Attach the tube between the
throttle body sleeve and the “bump” sleeve. The
stud on the rubber mount will mate with the
previously installed mounting tab. Adjust tube to
ensure adequate clearance to the drive belt. Install
the M6 locknut with washer onto the mount stud.
Tighten all clamps after all tubes have been
aligned and proper clearance adjustments have
been made throughout the charge tube route.
See Fig. 7G.
H. Re-install the two previously modified plastic OEM
side panels from into the cooling air feed cavity
into their OEM positions. Secure the bottom
portion of the panels to the CAC tubes using the
supplied mount tabs, M6 x 16 screws, nuts, washers
and clamps. See Figs. 7H, 7I.
I. Connect extended MAF harness connector to MAF
module on tube ‘C’.
J. Reinstall the headlight (if removed), bumper cover
and lower plastic cover panels.
Fig. 7H
Fig. 7I