Vortech 2013 Scion FR-S and Subaru BRZ - Manual (Page 32)

P/N: 4TF020-010 v2.1, 05/14/2013
©2013 Vortech Engineering, Inc
All Rights Reserved, Intl. Copr. Secured
25
NOTE:
Complete (non-tuner) kits include a
plug-and-play MAF extension harness
(Vortech p/n 5W001-094). Disregard the
following "cut and solder" portion of this
step if you have a MAF extension harness.
Simply plug the extension into the vehicle
harness and route down to the relocated
MAF module. Connect to the MAF module
and secure wires from sharp edges.
A. Locate the Mass Air Flow (MAF) sensor
harness previously attached to the airbox
cover. See Fig. 5A.
B. Carefully remove the electrical tape securing
the plastic split loom and expose the five
wires. See Fig. 5B.
C. Cut the five wires just above the shielding of
the white wire (approximately 2" from the
connector). Be sure to leave enough wire to
be stripped and soldered on each end. See
Fig. 5C.
Fig. 5A
Fig. 5B
Fig. 5C
5. MAF HARNESS EXTENSION