Vortech 2013 Scion FR-S and Subaru BRZ - Manual (Page 38)

P/N: 4TF020-010 v2.1, 05/14/2013
©2013 Vortech Engineering, Inc
All Rights Reserved, Intl. Copr. Secured
31
NOTE: On Subaru BRZ models, the passenger
side headlight must be removed in order
to properly install the charge cooler tubes.
A. Locate the supplied discharge tube 'B'
(simple 90 degree bend) and slide a 2-1/2"
silicone sleeve and pair of #36 clamps on
each end of the tube. Attach the long leg of
the tube to the driver side of the CAC.
Temporarily snug the clamps so the tube
does not fall out, but can still be moved
slightly. See Fig. 7A.
B. Locate the supplied discharge tube 'A' (with
welded 1” boss attached). From the top,
slide discharge tube 'A' behind the left
(driver side) headlight and into the sleeve
on discharge tube 'B'. Attach discharge tube
'A' to the supercharger with the “bump”
sleeve and #36 clamp provided. See Fig. 7B.
C. Secure tube 'A' to the previously installed
airbox support bracket using the #36 clamp,
mount tab, M6 screw, washers and nuts. See
Fig. 7C.
Fig. 7A
Fig. 7B
7. CHARGE AIR COOLER TUBE
INSTALLATION
Fig. 7C