Vortech 2013 Scion FR-S and Subaru BRZ - Manual (Page 37)

P/N: 4TF020-010 v2.1, 05/14/2013
©2013 Vortech Engineering, Inc
All Rights Reserved, Intl. Copr. Secured
30
J. Drop the remaining #20 hose clamp over the metal tube.
Attach the new tank assembly to the vehicle using two of
the original chassis mount locations and the supplied
M6 x 16 screws. See Figs. [6H, 6I). As the assembly is being
installed, ensure that the metal filler tube is inserted into
the rubber filler hose. Secure the connection with the #20
hose clamp.
K. Re-attach the OEM washer hose and connector to the
washer pump. The pump wiring harness may need to be
separated from the main harness in order to get the
connector to reach the new pump location. Do this by
carefully opening up the plastic harness cover with a razor
blade. Be careful not to cut into any of the wire insulation.
Re-tape and cover the original harness.
L. Fill the reservoir with appropriate washer fluid until
the level can be seen in the filler neck.
Fig. 6H
Fig. 6I