Xblue Networks X-50 - Manual (Page 79)

XBLUE Networks 79
Web Programming
Ph
one
6
•
Enable Call Waiting: - Check to enable “Call Waiting”, which allows your telephone to receive a second
telephone call, when you are busy on a call.
•
Enable Call Waiting Tone: - Check this parameter to enable the “Call Waiting Tone”, which is heard when
call waiting is enabled and a second call is programmed to ring on your extension.
•
Enable Hold Reminder: - Check this parameter to enable “Hold Reminder” which will remind you, with a
single tone burst, each time the Hold Reminder Time Expires.
•
Hold Reminder Time (sec): - Select how often, in seconds from zero (0) never to sixty (60) seconds, which
is how often the hold reminder tone should play.
•
Dial Timeout (sec): - This timer, in seconds, is the amount of time that passes after you dial a digit and the
call is placed.
•
Enable Block Anonymous Call: - Check this parameter to block calls that have a Caller ID that shows “Anon-
ymous.
•
LCD Backlit Time: - Check this parameter to limit the amount of time that a backlit display will be active.
•
Hotline Delay Time: Enter the amount of time that will pass after you pick up the handset or press the
speaker button, before dialing the “Hotline Number”.
•
Hotline Number: - Enter the number that should be dialed when the Hotline Delay Timer expires.
This timer also represents the amount of time that you can
pause between dialing digits in a telephone number.
Therefore, if this timer is set too short a call may begin
dialing if you pause or if you are looking up a number.
This parameter is used to make your telephone automatically
dial a number, feature or parameter, whenever the handset
is lifted or the speaker button is press. This may be used to
automatically access an outside telephone line, rather than
intercom.