Xblue Networks X-50 - Manual (Page 97)

XBLUE Networks 97
Web Programming
Sy
st
em
6
•
Enable Log Server - Click on the Check Box to enable the telephone log.
•
Log Level - Select which of the eight log levels, will be used when collecting information.
•
System Log Address: - Enter the IP address where the log file will sent while it is active.
•
System Log Port: - Enter the port to be used while the log is begin recorded. The default is set to Port 514.
•
System Language: - Select the language to be used. Currently, English is the only language supported.
Time Settings:
If you are connected to the Internet and have a time server programming into the “Time Server” parameter on the
“Network” page. You may skip the Auto DST, Daylight Savings Time, Starts on and End on parameters.
•
Auto DST: - Click the check box to enable automatic Daylight Savings Time.
•
Daylight Savings Time: - Select to add or subtract 1 hour from the current time.
•
Starts on: Enter the date that Daylight Savings Time starts.
•
Ends on: Enter the date that Daylight Savings Time ends.
•
Time format: - Select how you would like to see the time in your display. The default is “USA Time 12
Hours, which shows the date and time in MM/DD/YY HH:MM AM/PM settings.
TABLE 6.3 Log Levels
Level Information
Emergency (default) Logs only information that is considered to be a emergency by the telephone,
and most likely caused a total failure.
Alert Logs emergency information and any information that may alert the telephone
of a pending problem.
Critical Logs the above information and any critical information that the telephone is
not responding correctly.
Error Logs the above information and any errors in programming or performance of
the telephone.
Warning Logs the above information and any warning or pending problems
Notice Logs the above information and all notices from SIP and the network.
Informational Logs the above information and any SIP information, including setup, teardown
and network information.
Debug Logs the above information and all interaction between the telephone the net-
work and the gateway.
The use of “Debug” may interfere with the performance of the telephone.
TABLE 6.4
Setting Display
USA Time 12 Hour (Default) MM/DD/YY HH:MM AM/PM
USA Time 24 Hour MM/DD/YY HH:MM - 1:00=12:00, 2:00=14:00, 3:00=15:00 etc.
European Time 24 Hour DD/MM/YY HH:MM - 1:00=12:00, 2:00=14:00, 3:00=15:00 etc.
European Time 12 Hour DD/MM/YY HH:MM AM/PM