Altera RapidIO II MegaCore Function - Manual (Page 42)

3–12 Chapter 3: Parameter Settings
Error Management Registers Settings
RapidIO II MegaCore Function August 2014 Altera Corporation
User Guide
■ If you do not instantiate the Error Management Extension registers (refer to “Error
Management Registers Settings” on page 3–12 ), this parameter determines the
value of the EF_PTR field of the LP-Serial Lane Extended Features Block Header
register at offset 0x200 (
Table 6–16 on page 6–21 ).
■ If you instantiate the Error Management Extension registers in your RapidIO II IP
core variation, this parameter determines the value of the EF_PTR field of the Error
Management Extensions Block Header
register at offset 0x300 ( Table 6–66 on
page 6–43 ).
1
This parameter does not affect the Assembly Information CAR. The
ExtendedFeaturesPtr
in the Assembly Information CAR is set to the value of 0x100,
which is the offset for the LP-Serial Extended Features block (refer to Table 6–2 on
page 6–2 ).
Error Management Registers Settings
The Error Management Registers tab lists a single parameter, Enable error
management extension registers
.
If you turn on Enable error management extension registers, your RapidIO II IP core
instantiates the Error Management Extensions register block defined in the RapidIO
Interconnect Specification Part 8: Error Management Extensions Specification.
The RapidIO II IP core instantiates these registers at register block offset 0x300. If you
do not instantiate these registers, you can specify user-defined registers at offset
0x300.
The RapidIO II IP core Error Management registers are described in “Error
Management Registers” on page 6–42 .