Setup elements, Board settings dip switch, Setup elements –19 – Altera DSP Development Kit, Stratix V Edition User Manual

Page 27: Board settings dip switch –19

Advertising
background image

Chapter 2: Board Components

2–19

Configuration, Status, and Setup Elements

July 2012

Altera Corporation

DSP Development Kit, Stratix V Edition

Reference Manual

Table 2–11

lists the board-specific LEDs component references and manufacturing

information.

Setup Elements

The development board includes several different kinds of setup elements. This
section describes the following setup elements:

■

Board settings DIP switch

■

JTAG control DIP switch

■

PCI Express control DIP switch

■

MAX V reset push button

■

Program load push button

■

Program select push button

■

CPU reset push button

Board Settings DIP Switch

The board settings DIP switch (SW5) controls various features specific to the board
and the MAX V CPLD System Controller logic design.

Table 2–12

lists the switch

controls and descriptions.

D4, D5, D6 PGM_LED

PGM_LED0

PGM_LED1

PGM_LED2

The sequence displayed determines if the factory design or a
user design is used to configure the FPGA from flash when you
press the PGM_LOAD push button. Refer to

Table 2–9

for the

push button configuration settings.

D12

TEMP

OVERTEMPn

Red LED. Illuminates when a heat sink or fan should be installed.
Driven by the MAX1619 thermal sensor OVERTEMPn signal.

Table 2–10. Board-Specific LEDs (Part 2 of 2)

Board

Reference

LED Name

Schematic Signal

Name

Description

Table 2–11. Board-Specific LEDs Component References and Manufacturing Information

Board Reference

Description

Manufacturer

Manufacturer

Part Number

Manufacturer

Website

D1, D2, D4-D6, D15,

D17, D29-D32

Green LEDs

Lumex Inc.

SML-LX1206GC-TR

www.lumex.com

D16

Red LED

Lumex Inc.

SML-LX1206USBC-TR

www.lumex.com

D24

Blue LED

Lumex Inc.

SML-LX1206USBC-TR

www.lumex.com

Table 2–12. Board Settings DIP Switch Controls (Part 1 of 2)

Switch Schematic Signal Name

Description

Default

1

CLK_SEL

ON : SMA input clock select.

OFF : Programmable oscillator input clock select (default 100 MHz).

OFF

2

CLK_ENABLE

ON : On-Board oscillator enabled.

OFF : On-Board oscillator disabled.

ON

Advertising