MIPRO ma707 - Manual (Page 13)

Handheld Wireless Microphone
(Fig.2)
Operating Manual
- 11 -
6. Power On-off Switch: Slide the switch for power " ON" or "OFF".
7. Group Changer Cover: Open cover to switch to Group Frequency Selection.
8. Channel Selection Cover: Open cover to switch to desired frequencies.
9. Unused Indicator: When LED glows it indicates an untransmitt signal or an empty
group or channel was selected. When microphone is power ON, LED will glow for
approx. 2 seconds and then fades.
10.Selector Cover: Protect channel changers and accidental switching.
11.Battery Cap: Covers the battery compartment.
Operating Instructions
1. As the microphone is switched on:
When the power is switched on, the indicator will flash briefly indicating normal
operation.
2. After microphone is switched on:
The SIGNAL LED indicator on receiver glows. The more LEDs that glow
indicate that the received signal strength is stronger. If only the red LED illuminates
it indicates abnormal receiving status and insufficient signal strength.
3. During Usage:
The AUDIO LED indicator on the receiver will illuminate according to the audio
signal strength from the microphone. When the red LED is ON, it indicates that
maximum sound pressure level has been reached but does not represent distortion.
4. When the microphone is not in use:
Make sure that you turn off the microphone after use to extend the battery life.
Remove the battery from the battery compartment if microphone is not to be used
again for some time. If a rechargeable battery was used, take it out and recharge it.
1. Unscrew battery cap in counter-clockwise direction (Fig. 2).
2. Insert a 9V battery into the battery compartment according to the correct polarity as
shown in Fig.2. The moment the battery touches the terminals of compartment, the
indicator (5) will flash briefly. This means the polarity is correct. However, if no flash
occurs, this indicates wrong insertion. Please re-insert the battery according to its
correct polarity.
Battery Installation