MIPRO ma707 - Manual (Page 14)

1. Phone Jack Input Connector: Connects to a phone jack 3.5mm connector (if so
configured). Allow for lavalier and headset microphones.
2. 4-Pin Jack Input Connector: Connect to a MIPRO 4-pin connector (if so configured).
Allows 5 for different input connections. (See 5 ways of connection on AF Input
Connections later in this booklet).
3. Volume Control Bypass Switch (if fitted): When the switch is in the 'up' position, the
volume control is bypassed and the level is set to maximum. When switch is at
'down' position the volume control is fully operational.
4. Volume Control: Adjusts the audio input level from the microphone/auxiliary source,
to the transmitter.
5. GT/MT Switch (if fitted): Switch to the GT position for electric guitar usage ONLY.
The Gain Control is bypassed in "GT" mode. Switch to the "MT" for condenser
microphone, wired microphone or Line-in. The Gain Control operates in the "MT"
mode for adjusting input sensitivity.
6. Gain Control: Adjusts the input gain. Please take care not to inadvertently turn the
level down for a loss of signal, or up to induce feedback.
7. Transmitter Housing: Houses the PCB and battery.
8. Battery Status Indicator: Indicates the power on / off and battery status.
(a) When power switch is turned on the LED indicator flashes briefly, indicating
normal battery status.
(b) When the RED light illuminates at either power on or during use, it indicates
that the battery level is low, therefore a new battery is required.
9. Power Switch: Switch to ON position for operation. Switch to OFF position when not
in use.
10. Battery Compartment and Cover: Accommodates one 9V battery.
11. Detachable Belt Clip: Pull slightly towards you and push down according to the
arrow direction to release the belt clip.
Features
Belt Pack Transmitter
(4 PIN JACK) (PHONE JCAK)
MIC
L O
C K
3
ON
11
4
9
8
OFF
V O L U M
E
7
10
BATT.LOW
1
MIC
2
BATT.LOW
OFF ON
9
10
8
7
5
11
6
G
A IN
M T
G T
Operating Manual
- 12 -