MIPRO ma707 - Manual (Page 17)

VHF
PLL
UHF
1
2
3
5
6
9
10
12
11
8
7
4
Belt Pack Transmitter
Operating Manual
Features
(XLR JCAK)
(Fig.1)
1. AF Input Jack: Connects to either lavaliere or headset microphone. (See 5 ways of
connection on AF Input Connections)
2. Power Switch: Switch to ON position for operation. Switch to OFF position when
not in use.
3. Battery Status Indicator: Indicates the power on / off and battery status.
(a) When power switch is turned on: The LED indicator flashes briefly, indicating
normal battery status.
(b) When RED light illuminates at either power on or during usage: The battery
level is low, therefore, a new battery replacement is thus necessary.
4. Transmitting Antenna: 1/ 4 transmitting antenna.
5. Transmitter Housing: Packages the PCB and battery.
6. Group Changer: For Group Selection. (UHF)
7. Channel Changer: Preprogrammed with 30 frequencies. Allow 1-30 channels
switchable option. (UHF / PLL)
8. Unused Status Indicator: When LED lights on, it denotes un-transmitted signals.
9. Gain Control: Adjusts the desirous input gain.
10. GT/MT Level Select Switch: Switch GT position for electric guitar usage ONLY.
Gain Control is irrelevant for "GT". Switch to "MT" for condenser microphone,
wired microphone. Gain Control works in "MT" for input sensitivity adjusting.
11. Battery Compartment and Cover: Accommodates one piece 9V battery.
12. Detachable Belt Clip: Pull slightly towards you and push down according to the
arrow direction to release the belt clip.
- 15 -