CIRCUTOR CIRLAMP Series User Manual
Page 86
8�- EXPANSION MODULE: M8I8O
8.1.- INSTALLATION OF THE UNIT
8�1�1� PRELIMINARY RECOMMENDATIONS
See section
“4�1�1� PRELIMINARY RECOMMENDATIONS”�
8�1�2� INSTALLATION
Terminals, opening covers or removing elements can expose parts that are
hazardous to the touch while the unit is powered. Do not use the unit until it is
fully installed.
Disconnect the
CirLAMP Manager from all power supply sources before con-
necting the
M8I8O module.
The first step in installing the
M8I8O module is to remove the protective cover from the
expansion connector on the right-hand side of the
CirLAMP Manager,
Figure 95: Remove the protective cover from the CirLAMP Manager expansion connector�
Connect the
M8I8O expansion module,
�
Figure 96: Connect the M8I8O expansion module�
86
CirLAMP system
Instruction Manual