CIRCUTOR DHB Series - Manual (Page 13)

13
Þ moving through the menu – choice of level,
Þ entry in the mode changing the parameter value,
Þ acceptation of the changed parameter value,
Þ stop the measurement – when holding down the button, the result
on the display is not updated.
The measurement is still carried out.
- button increasing the value:
Þ display of maximal value, The pressure of the button causes the
display of the maximal value during ca 3 seconds,
Þ entry in the level of the parameter group,
Þ moving through the selected level,
Þ change of the selected parameter value – increasing the value.
- button changing the digit:
Þ display of minimal value, The pressure of the button causes the
display of the minimal value during ca 3 seconds,
Þ entry in the level of parameter group,
Þ moving through the selected level,
Þ change of selected parameter value – shift on the next digit,
- resignation button:
Þ entry in the menu monitoring the meter parameters (by holding
down ca 3 seconds),
Þ exit from the menu monitoring meter parameters,
Þ resignation of the parameter change,
Þ absolute exit from the programming mode (holding down
ca 3 seconds).
The pressure of the button combination and holding
them down ca 3 seconds causes the erasing of alarm signaling. This
operation acts only when the support function is switched on.
The pressure of the
button combination causes the era-