CIRCUTOR DHB Series - Manual (Page 8)

8
Fig. 3. Overall Dimensions
Fig. 2. Meter Fixing
4. INSTALLATION
The meter has separable strips with screw terminals, what enables the
connection of external wires of 1.5 mm
2 cross-section for input signals
and 2.5 mm 2 for other signals.
One must prepare a hole of 92 +0,6 ´ 45 +0,6 mm in the panel, which the
thickness should not exceed 6 mm.
The meter must be introduced from the panel front with disconnected
supply voltage. Before the insertion into the panel, one must check the
correct placement of the seal. After the insertion into the hole, fix the
meter by means of clamps (fig. 2).