CONTA-CLIP CONTA-Sign 5.2 - Manual (Page 28)

Page 28 of 67
- Round frame corners
If you select this option, a combo box appears in which you can set the radius to the
corners. You can set radii from 1 mm to 5 mm, graduated in steps of .5mm.
- Engrave holes on tags with lettering only
If you select this function, holes, if designed, will be engraved only on tags containing
lettering.
- Engrave holes on all tags
If you select this option, holes, if designed, will be engraved on all tags.
- Test plot
If you select this option you can test the engraving design using a pen before starting
the engraving job.
Note:
For making the test plot a special adapter, available as option, is needed in order to
hold the pen in place for plotting, inserted into the engraving head.
This feature is supported by the dedicated engraver only.
- Engrave tag contour only
Checking this box will enable you to just engrave the tag contours.
- Speed for tag contour
You can use this section to set the engraving speed, the revolution speed (RPM) of the
engraving spindle and the penetration speed for the engraving spindle for the material
being engraved. The parameters are pre-set as factory default
Note:
In principle, lettering is always engraved first, followed by the contours, as long as the
relevant parameters have been set.
- Setting the engraving material thickness
At the right side of the window you need to set the material thickness, if not already
displayed. Click on the combo box and select the material accordingly.
Note in general:
All in green indicated letterings and graphical elements such as holes, frames etc. will
be engraved according to your settings done.