2 dolby atmos content not recognized, 3 kdms for dolby atmos content (cpl), 4 dolby atmos channel drop out – Doremi DCP-2000 User Manual
Page 30
5.2 Dolby Atmos Content Not Recognized
If the Dolby Atmos content is not recognized, a gray or red dot will be present in the Dolby Atmos
Content section. (Refer to Figure 29)
Use the tips below to try and solve the issue:
•
Verify the selected content is Atmos content. (Refer to Section 3.2 on how to verify the
content).
•
Verify the audio processor is Enabled. (Refer to Section 3).
5.3 KDMs for Dolby Atmos Content (CPL)
All KDMs created to unlock encrypted Dolby Atmos content must have the audio watermark disabled
from only channels 12 and above.
Below is an example of what a correct KDM would look like:
•
<ForensicMarkFlagList>
<ForensicMarkFlag
</ForensicMarkFlagList
5.4 Dolby Atmos Channel Drop Out
If the system experiences Dolby Atmos drop out, when the system is only outputting the base bed
audio channels, (that being the first 10 physical channels, e.g. 5.1 or 7.1). The reason could be
network drop out or the network is not running fast enough.
Check which ethernet port your CP850 is on, e.g. 10.203.50.10
In the drmreport.txt, search for "IP Interfaces"
Example 1 - Dropped Packet
eth0 Link encap:Ethernet HWaddr 00:25:90:74:08:F8
inet addr:10.203.50.204 Bcast:10.203.50.255 Mask:255.255.255.0
inet6 addr: fe80::225:90ff:fe74:8f8/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:103696968 errors:0 dropped:
12866
overruns:0 frame:0
TX packets:34997690 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:1007555312 (960.8 MiB) TX bytes:3127287593(2.9 GiB)
Base address:0x2000 Memory:d0300000-d0320000
D2K.OM.003651.DRM Page 30 of 33 Version 1.1
Doremi Labs