Holland Electronics NE 1100 User Manual
Page 20
20
NE1100A2 CATV Optical Receiver Operation Manual
6.1 Strand Mounting
Use the 2 clamps on the top of the receiver housing to hang the receiver from the cable strand.
(See fig.9). Tighten the clamp bolts securely to lock the receiver to the cable strand.
6.2 Wall Mounting
1) There are (10) threaded mounting holes in the back of the receiver housing. Refer to fig.11
for the hole pattern and spacing.
2) Drill the holes in the wall. Use a minimum of 6 screws to attach the receiver to the wall (see
fig. 10).
6.3 Grounding/Lightning Strike Protection
The receiver must be properly grounded to prevent damage from lightning. Use any of the
receiver housing screws to attach a wire from earth ground.
Figure 9. Illustration of cable- mounted practical installation