Junger Audio MIX4 Small Desktop Mixer - Manual (Page 16)

Jünger Audio-Studiotechnik GmbH
page 13
Continuing to turn the Channel Rotary Knob to the right will select the next possible source, which would
be the right channel of the 2-channel source “VTR_3 R” in this example :
L C R 1 2 3 4 L C R 1 2 3 4 L C R 1 2 3 4 L C R 1 2 3 4
- - -
^
x
R I G H T
- - x - - x
M i c 1 V T R _ 3 R C D 3 J i N g l e 1
L C R 1 2 3 4 L C R 1 2 3 4 L C R 1 2 3 4 L C R 1 2 3 4
- - -
^
x
S T E R E O
- - x - - x
M i c 1 V T R _ 3 C D 3 J i N g l e 1
You may also select the opposite channel via “3 push” by pressing the Channel Rotary Knob several times
or by the standard turning function of that knob.
Important Note! Stereo / 2-channel switch over is only possible via pressing of the Channel Rotary Knob.
While source selection is possible by either turning or pushing the Rotary Knob.
If in continuous operation for 2-channel mode the content of the channels has changed (usually happens
with VTRs when voice on track one and clean feed on track two or vice versa) you can quickly switch to the
other channel by pressing <SRCE> and then the respective channel rotary knob. The underscore in the
upper line of the display changes from L to R respectively (or vice versa).
If a stereo source is selected for that Channel Strip, pushing the Channel Rotary Knob alternates between :
mono (L+R -3dB) marked by an underscore under C
and
stereo (without underscore).
Pushing <SRCE> again terminates the source selection.
Router Tie Line Inputs
It is possible to configure Mix 4 line inputs to be connected to Tie Lines, which in turn are connected to an
external router. This router can then be controlled by the Mix4 to allow selections of its inputs to be routed to
the Mix 4 Inputs.
If the MIX4 is connected with an external router, special MIX4 firmware to interface to the control
system of that router must be installed and activated in the MIX4.
The first time you dial up one of these tie line inputs on the Mix4, the display will show both names preset in
Setup software and the Channel Button will start blinking green/yellow to show this special situation :