Junger Audio MIX4 Small Desktop Mixer - Manual (Page 18)

Jünger Audio-Studiotechnik GmbH
page 15
Important note! When you are selecting an external source for the MIX4
(see above) there are two ways to leave this mode (see 4.1 or 4.2 below) :
0.
Turn source selection mode on by pressing the <SRCE> button.
1.
Select a Channel Strip where you want to assign an external source to.
Press a Channel Button - Channel Button is blinking green.
2.
Search for an input (tie line) that is connected to an external router destination port.
Turn the Channel Rotary Knob until - Channel Button is blinking green / yellow.
3.
Turn external control on.
Press that Channel Button - Channel Button is blinking red/yellow or yellow
3.1 Select a source if blinking yellow (Klotz Digital VADISII)
Turn the Channel Rotary Knob to select a source
3.2.1 Select a Group if blinking red/yellow (LAWO / Mandozzi / DHD)
Turn the Channel Rotary Knob to select a group
3.2.2 Select a source from a (pre selected) group.
Press that Channel Button again - Channel Button is blinking yellow
Turn the Channel Rotary Knob until the router source name appears in the Channel
4.
Turn source selection mode off.
4.1
Press <SRCE> button - Channel Button turns off
The name of the external source will stay in the Channel Display.
4.2
Press that Channel Button - Channel Button turns off
The name of the local input (i.e. the name of the tie line) will appear in the Channel Display
You must press <SRCE> afterwards to leave source selection mode!