Junger Audio MIX4 Small Desktop Mixer - Manual (Page 46)

Jünger Audio-Studiotechnik GmbH
page 43
Set up the MIX4 to remote control Madozzi router functions
The procedure to prepare a MIX4 controlling the Mandozzi router is quite simple. Pls. ensure that the MIX4
and the PC, where the Setup software is running on, are connected to the LAN where the Firewall PC
resides. In case of unknown IP configuration you must have serial connection with the MIX4.
1.
First you must go to the Hardware page and perform a “from Device” to load the current settings into
the Setup software.
2.
You must assign a unique IP address and subnet mask to the MIX4 as well as a gateway address if
necessary (pls. contact the system administrator for IP addresses). Such IP configuration will only be
valid after a power cycle of the MIX4.
2 The “Name:” field is optional and can be left blank
3.1 On the Router page you must enter the IP address of the Mandozzi Firewall PC.
3.2 If the application port number is different from 50000 that number will appear below
Configuration > IP-Address. You must correct it to 50000 for proper operation.