Paxton Superchargers Mustang Novi 2000 - Manual (Page 10)

2-2
P/N: 4809610
©2003 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
05DEC03 v2.0 MusGT(4809610 v2.0)
Fig. 2-e
Fig. 2-f
J. Loosen the petcock at the bottom of the
radiator and drain approximately one gallon
of coolant into a drain pan. (Save fluid for
re-use.)
K. Disconnect the overflow hose from the neck
of the radiator and unplug the electrical con-
nector from the coolant bottle.
L. Using a 7/16" combination wrench, loosen
the four bolts that are securing the fan to the
water pump. With an18mm combination
wrench release the tension on the belt ten-
sioner and remove the factory drive belt.
Now remove the four bolts that are securing
the fan to the water pump. (See Figs. 2-c.)
M. Using a 10mm socket & ratchet or screw
driver, loosen the clamps and remove the
upper radiator hose from the vehicle. Save
for re-use.(See Fig. 2-d.)
O. Using a nut driver or screwdriver, remove
the clamps securing the rubber inlet tube to
the throttle body and mass air flow sensor
and remove the inlet tube.
P. Loosen the clamp securing the mass air flow
sensor to the rubber sleeve at the air filter
assembly. Unplug the sensor and un-bolt it
from the strut tower with a 7/16" socket.
Q. Using a 7/16" deep socket, loosen the nuts
securing the air filter assembly to its rubber
mounts and remove the filter from the vehi-
cle. Unscrew the rubber mounts from the
inner fender. (See Fig. 2-f.)
Fig. 2-c
Fig. 2-d
N. Using a 7/16" wrench or socket, remove the
two sheet metal screws securing the fan
shroud to the radiator core support and
remove the shroud fan clutch from the vehi-
cle. (See Fig. 2-e.)