Paxton Superchargers Mustang Novi 2000 - Manual (Page 5)

v
P/N: 4809610
©2003 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
05DEC03 v2.0 MusGT(4809610 v2.0)
N ever rely solely on a hydraulic lift, when
working under a vehicle. Always use
approved jackstands to support the vehicle
and place them under the manufactures recom-
mended lift points.
When lifting the vehicle, make sure it is on a level
surface, preferably concrete or asphalt. The trans-
mission should be in “PARK” or “FIRST”, the
parking brake engaged, and the wheels blocked.
Never start the car with out first verifying that the
transmission is in neutral and the parking brake is
set.
Never remove the radiator cap while the engine is
still hot. Always wear eye protection when using
power tools such as drills, saws, grinders, etc., or
when working under a vehicle.
Never smoke, use an open flame, or have spark-
producing items around gasoline or flammable sol-
vents. Always have a fire extinguisher rated for
chemical and electrical fires handy when working
on motor vehicles.
Run engines only in a well ventilated area.
Carbon monoxide, gasoline and solvent vapors are
colorless, and sometimes odorless. These can
asphyxiate or explode without warning.
Always disconnect at least the (-) negative or
ground terminal of the battery when doing any
electrical, fuel system, or under dash work.
We look forward to hearing from you, particularly
if you have any comments or suggestions regarding
this manual at (805) 604-1336 Paxton Automotive
Corporation, 1300 Beacon Place, Oxnard, CA
93033. E-mail Address:
[email protected]
***NOTE***
Through these procedures the word “discard” is
used periodically in relationship to items that will no
longer be utilized in conjunction with the supercharg-
er installation. It is recommended that these items be
saved for future use should it become necessary.
RECOMMENDED TOOLS
FOR INSTALLATION:
1. Metric and Standard sockets
sets
2. Metric and Standard com-
bination wrenches
3. Phillips and common screw
drivers
4. 12” crescent wrench or 36mm open
end wrench
5. Pliers
6. Wire cutters and wire crimping tool.
7. Hose cutters
8. 1/8” drill bit and hand drill
37/64 drill bit
9. Allen wrenches
10. Small heat source
11. 3/8 Tap NPT
12. Air Hammer
13. Air Compressor