Paxton Superchargers Mustang Novi 2000 - Manual (Page 7)

1-1
P/N: 4809610
©2003 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
05DEC03 v2.0 MusGT(4809610 v2.0)
C ongratulations! You have purchased the
finest street Supercharger available for the
1986-1993 Ford Mustang 5.0. The center-
piece of this kit is the highly efficient and reliable
Paxton Automotive Corp. NOVI-2000 supercharg-
er. A mechanically driven (by belt) centrifugal
supercharger.
This kit comes with all of the parts you’ll need for
a successful installation. The operations required
have been grouped in order of sequence. Photos
and drawings accompany the text, allowing quick
orientation and parts identification.
Installation requires a selection of tools which are
listed in a table at the end of this section.
We also suggest that you obtain a Ford shop manu-
al and become familiar with the details of your cars
systems. Manuals may be obtained from your
local Ford dealer or you can order one from Helm
publications at (800) 782-4356.
For best results follow the instructions closelyand
in sequence. The average installation time for this
kit is 8-10 hours. Your actual installation time will
depend on skill level and working conditions. The
estimate does not include time for initial vehicle
inspection, cleaning, fine
tuning or troubleshooting. Before even picking up
a wrench, read this entire manual. We are available
for technical assistance at
(805) 604-1336, 7am-3:30pm pacific time.
After reading the manual, verify that all major
assembly groups are present in the main kit box.
You should have ample space to layout the compo-
nents. As you remove a box or bag from the main
kit, note the identification label
and compare it with the parts list. Please check the
box for small parts.
Paxton makes every effort to insure that all parts
are included in the box. However, if you discover
any missing or mislabeled parts, please contact
Paxton by phone for service.
***WARNING***
DO NOT attempt installation if any part(s) are miss-
ing from this kit. Failure to contact Paxton prior to
beginning installation will result in a charge for any
missing parts.
Before starting the installation, we suggest your
engine compartment be clean. You can clean the
engine and compartment with a pressure washer
(such as those used at self serve car washes) and a
safe-for-aluminum cleaner/degreaser. Cover the
distributor with a plastic bag to prevent water from
entering.
***CAUTION***
We do not recommend proceeding with the kit instal-
lation unless your vehicle is within normal operating
parameters.
You are undoubtedly enthusiastic about getting
started on your project, but take just a little more
time to insure that your safety is not jeopardized. A
moment’s lack of attention can result in an acci-
dent, as can failure to observe certain simple safety
precautions. The possibility of an accident will
always exist, and the following points should not
be considered a comprehensive list of all dangers.
Rather, they are intended to make you aware of the
risk and to encourage a safety conscious approach
to all work you do on your vehicle.
Section 1
INTRODUCTION