Paxton Superchargers Mustang Novi 2000 - Manual (Page 15)

3-3
P/N: 4809610
©2003 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
05DEC03 v2.0 MusGT(4809610 v2.0)
Fig. 3-g
F ig. 3-h
S. There are three (3) countersunk holes left in
the support plate. They each take the
remaining 3/8" x 3 1/4" counter sunk bolts.
Install these bolts and tighten to 28-30 ft
pounds. Upon completion of this step, tight-
en all of the remaining bolts that have been
left hand tight, as well as the Smog and
alternator assemblies.
T. Use the supplied 1/2" x 3 1/2" carriage bolt,
nut and washer to secure the factory belt
tensioner to the new bracket. Tighten nut to
28-30 ft lbs.. (See Figs. 3-j, 3-k.)
O. Install the steel braided -4 oil line on to the
-4 fitting of the street TEE. Neatly route the
hose across the front of the engine, behind
the accessories and under the supercharger.
(See Fig. 3-g.)
P. Bolt the Supercharger to the mounting
bracket with one of the 3/8" x 1" bolts and
washers through the upper most hole and the
two lower holes in the mounting plate. Place
the support plate over the front of the super-
charger and secure with the 3/8" counter-
sunk bolts. (See Fig. 3-h, 3-i.)
Q. Install the 3/8" x 2 1/2" countersunk bolt
through the lower most hole in the support
plate and thread it into the mounting plate.
Do not tighten this bolt. (See Appendix B.)
R. Above that, insert two of the 3/8" x 3 1/4"
bolts with washers through the support plate,
spacer and mounting plate. Secure the
accessory drive belt tensioner to the back of
the mounting plate with the upper of these
two bolts holes, the lower with the 3/8" x 1"
bolt and washer provided. Secure the other
side of the belt tensioner bracket to the stud
at the top of the water pump with the 3/8"
nut and washer. Do not tighten these bolts.
(See Fig. 3-i)
F ig. 3-i
ATTACH THE OIL HOSE FROM THE
STREET TEE TO THE FITTING ON
THE SIDE OF THE SUPERCHARGER