Paxton Superchargers Plymouth Prowler User Manual
Page 18
6-2
P/N: 4809629
©2003 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
22OCT02 v2.0 PlymProwler(4809629v2.0)
D.
Bolt the alternator support arm to the ear on
the alternator. Leave it slightly loose so it
can be adjusted. Next, mount the alternator
to the bracket. You will have to bend the Oil
Dipstick tube up and away from the bracket
to make room for the alternator.
(See Fig. 6-4.)
Fig. 6-4
Fig. 6-5 /
Complete installed Drive Belt Tensioner.
Fig. 6-6
H.
Complete the alternator wiring. Install the
drive belt tensioner. (See Fig. 6-5.)
I.
Refer to Fig. 6-6. Replace the factory bolts
with two 6mm Buttonhead screws from the
A/C Tensioner Assembly (p/n 1016032).
E.
Loop the supplied V-belt around the crank
pulley, then around the A/C compressor.
F.
Remove the two 10mm head nut and brack-
et, the 15mm head bolt/stud and the 15mm
head bolt.
G.
To install the A/C tensioner, place the belt
over the lower pulley, then under the top
adjuster pulley.
*****NOTE:*****
The tensioner pulley will push down on the belt,
so make sure the pulley is at the uppermost
position. Now bolt the bracket to the engine.
Tighten the bolt by turning the screw count-
er-clockwise. When the bolt is sufficiently
tight, tighten the lock nut on the front of the
A/C tensioner assembly.