Paxton Superchargers Plymouth Prowler - Manual (Page 31)

12-1 P/N: 4809629
©2003 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
22OCT02 v2.0 PlymProwler(4809629v2.0)
12.1 INSTALLING THE AIR INTAKE
ASSEMBLY (APPENDIX 1016043)
A. Install the supplied 45° fitting and position
to provide the maximum clearance between
the headers and the vent line.
(See Fig. 12-1.)
Fig. 12-1
B. Attach the adapter hose (item #7) to the
supercharger, using the #48 hose clamp.
Leave clamp loose at this point.
C. Attach the Nipple Fitting (item #12) to the
Compressor Bypass, and then to the Air Box
(item #1). Attach the box to the supercharg-
er.
D. Secure the box to the engine using the
bracket (item #13). You may have to trim
the turbo hose between the supercharger and
air box to clear the headers and fit the
mounting bracket.
E. Tighten all of the clamps at this time.
F. Attach the Vent Tube to the box. The tube is
brought along the firewall splitloom, and
attached to the passenger intake manifold.
(See Fig. 12-2.)
G. Assemble the Air Filter and attach it to the
Air Box. Thread the steel rod (item #11)
through the box, and thread a nut and wash-
er on the end. Place the restrictor, plate, fil-
ter element, tube, and plate onto the rod.
Finally, secure the assembly with the knob.
(See Fig. 12-3.)
Fig. 12-2
Fig. 12-3
H. Reattach the oxygen sensor to the manifold
and plug back into the electrical connection.
I. Reattach the driver side support rail and the
support rods. Finally, reattach the outer body
panels on the passenger and driver’s side.
Section 12
INSTALLING THE AIR INTAKE ASSEMBLY
AIR BOX VENT TUBE
ECU VACUUM