Paxton Superchargers Plymouth Prowler - Manual (Page 19)

7-1 P/N: 4809629
©2003 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
22OCT02 v2.0 PlymProwler(4809629v2.0)
Section 7
INSTALL THE MOUNTING BRACKET ASSEMBLY
AND SUPERCHARGER
7.1 INSTALL THE MOUNTING BRACKET
ASSEMBLY AND SUPERCHARGER
A. Remove the two 10mm Head Bolts and
replace them with the Buttonhead allen bolts
supplied with the mounting bracket assem-
bly (P/N: 1016034). (See Fig. 7-1.)
Fig. 7-1
B. Bolt the supercharger mounting bracket to
the front of the engine using the four 8mm
bolts and one 10mm bolt (See Appendix
1016034 for the proper bolt placement.) The
bracket fits behind the power steering pul-
ley. You must put the 3/8-16 x 3-1/4” long
bolts (item #8) in the lowermost outer holes
in the bracket before installation. (See Figs.
7-2, 7-3.) shows the installed Mounting
Bracket.
Fig. 7-2
S/C mounting bracket from front of engine (pulleys attached).
10mm HEAD BOLTS
PUT THESE
BOLTS IN
FIRST
POWER STEERING
PULLEY
Fig. 7-3
S/C Mounting bracket from rear of engine
C. Test fit the supercharger by laying it into the
mounting bracket. You will need to trim the
body panel for clearance. Do not permanent-
ly attach the supercharger yet.
(See Fig. 7-4.)
Fig. 7-4