Paxton Superchargers Plymouth Prowler - Manual (Page 8)

1-2 P/N: 4809629
©2003 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
22OCT02 v2.0 PlymProwler(4809629v2.0)
*****NOTE*****:
You may notice a “burning rubber” smell when
the vehicle is first fired up and immediately after
the first long hard full throttle pulls you do. This
is caused by the special composition header
gaskets “burning in” and takiing a set. However,
please feel free to check and double-check that
no hoses or rubber components are beinng
incinerated.
PROWLER DIAGRAM
For removing stock head pipe for header installation
STOCK HEAD PIPE 2-1/4”
MEASURE 1/4” ABOVE WELD, CUT AND REMOVE USING A BASIC MUFFLER
SHOP EXPANDER OR HAND HELD. EXPAND THIS UP TO 2-1/2” O.D.
2-1/2” 3-BOLT FLANGE
BOLT FLANGE TO COLLECTOR INDEX
CAT INTO FLANGE TACK WELD OUTSIDE
REMOVE AND FINISH WELD INSIDE