Paxton Superchargers Plymouth Prowler - Manual (Page 20)

7-2 P/N: 4809629
©2003 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
22OCT02 v2.0 PlymProwler(4809629v2.0)
D. Install the oil drain fitting on the supercharg-
er. Install a 2” long turbo hose (from the dis-
charge tube assembly p/n 1016049) onto the
discharge of the supercharger using a #48
hose clamp (place the screw of the clamp in
towards the supercharger). (See Fig. 6-4.)
Fig. 6-4
TURBO SLEEVE
OIL DRAIN
E. Install the supplied Lower Radiator hose
(P/N: 1016055) to the engine.
F. Relocate the wiring harness that runs under-
neath the supercharger by drilling a new
hole and attaching the harness with a ZipTie.
(See Fig. 6-5.)
Fig. 6-5
NEW HOLE
DRILLED
Attach the oil feed and oil drain hoses to the
supercharger, making sure they won’t come
in contact with the exhaust manifold, hot
engine surfaces, or hit anything when the
engine rocks. The oil drain fitting can be
turned to make adjustments in the line place-
ment.
H. Affix the remaining smooth idler pulley to
the last open hole in the mounting bracket.
Install the accessory/supercharger drive belt.
(See diagram 7000110.)
G. Mount the supercharger to the bracket, but
leave the four 3/8” bolts slightly loose.
*****NOTE*****
The discharge tube points straight down. Start
the three countersink allen bolts and tighten
using a 7/32 allen wrench. Go back and tighten
the 3/8” bolts, using a 9/16 socket.