Paxton Superchargers Plymouth Prowler - Manual (Page 9)

2-1 P/N: 4809629
©2003 Paxton Automotive
All Rights Reserved, Intl. Copr. Secured
22OCT02 v2.0 PlymProwler(4809629v2.0)
Section 2
SUPERCHARGER INSTALLATION
A. Disconnect the battery
B. Using a 10mm socket, remove the 3 bolts
securing the body panel immediately in front
of the driver’s door. Pull it out at the top
then lift up to remove. Disconnect the side
marker light. (See Fig. 2-1.)
C. Using a 13mm socket, disconnect the sup-
port rods (that go over the top of the engine)
at the rear of the engine compartment.
Leave them connected to the radiator sup-
port plate. (See Fig. 2-2.)
D. Using a 13mm and a 10mm socket, discon-
nect the upper radiator support and remove
the upper radiator support and the support
rods covering the engine. If your car has the
hood support as part of this assembly, you
will need a prop rod to support the hood
during the rest of the installation. (See
Fig. 2-2.) Place the front end of the car on
jackstands as near to the engine supports as
possible. (See Fig. 2-3.)
2.1 DISASSEMBLY
E. Disconnect the plug at the top of the fan
shroud (see Fig. 2-4). From under the vehi-
cle, loosen the petcock on the passenger side
of the radiator and completely drain the
coolant into a bucket. If coolant is not
reusable, please dispose of it properly.
Disconnect both upper and lower and radia-
tor hoses and remove the lower radiator
hose. Disconnect the wiring harness from
the fan shroud. Using a 10mm socket,
remove the two bolts that secure the radiator
to the A/C condenser, and remove the radia-
tor by lifting it straight up.
REMOVE
DISCONNECT
SUPPORT RODS
REMOVE
WIRING
HARNESS
Fig. 2-1
Fig. 2-2
Fig. 2-3
Fig. 2-4